Another talent of UX
platform, it can extend a life of existing equipment and bring it into VoIP
infrastructure easily and seamlessly! I am talking about Adit600 Channel bank.
There are multiple deployments of Adit600 for FXS ports, specifically Interactive
intelligence CIC platform was using Adit's channel banks as FXS device for
analog lines. Usually replacement on TDM card based CIC resulted in
decommissioning Adit's and replacing them with FXS Gateways for analog devices.
Not anymore! Now it is possible to keep using investment into Adit600 channel
banks.
Even better with UX
platform ADIT600 can find a new life in Lync environment! UX2000 allows seamlessly integrate Adit600 into Lync environment as analog end-points.
Here is how the
whole setup looks like:
There is no
configuration required on Adit600.
On UX there are just
several configuration steps and Adit600 ready to dial!
First create CAS FXS
Profile:
Next, configure T1
port for CAS:
Next, create CAS
Signalling Group. Specify Line type as Digital, CAS Signalling Profile as FXS.
Assign Line
extensions, all 24 of them.
Create
Transformation table for Adit intercom routing:
Create Routing Table
entry:
Now connect a phone
to Adit600, listen to dial tone and dial!
I tested Adit600
intercom calls and calls through Ux to Tenor.
I haven't tested
Supplementary services like Hold, Transfer.
